Characterization of the Bendability of Press‐Hardened 22MnB5 Steel

  • vsundar
    Keymaster
    23

    #1628

    The three dimensional analysis of the surface morphology was done using the ROBO-MET 3D automated sectioning equipment in order to analyze surface roughening of the outer bend surface quantitatively. The three-dimensional image analysis was done with the Avizo 6 software. Samples for 3D surface visualization were polished with a 3micron diamond suspension. The average layer thickness was approximately 0.5micron. The surface roughening was measured on a 130micronx310micron area.

    Attachments:
    You must be logged in to view attached files.
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Characterization of the Bendability of Press‐Hardened 22MnB5 Steel